The B-YMP has been developed and desigend especially for you by Alexander Braun.
This allows a tailor made service, which allows us to provide topmost quality and care for your boat at the leastmost expense. Furthermore we keep a full service history, which can be viewed by our customers at any time.

 

Maintenance schedule

• N.B start both generators and make all breakers on arrival to enable following routine to be carried out.

Exterior

Anchor windlass

• Check oil level monthly
• Motor in both directions by disengaging clutch
• Release band brake ensuring clutch engaged. Inch windlass in both directions under power, re-apply band brake
• Apply wash water for 5 seconds
• Inspect condition of anchor chain and chain locker
• Inspect locker hatch for correct operation and ease of movement

Windscreen wipers

• Check security of fastenings
• Check condition of wiper blades
• Test and re-aim washers as reqd
• Test operation of wipers  

Side - stern doors, and hatchways

• Test smooth operation of lock
• Clean and lubricate rollers and sliding bolts as reqd
• Inspect door seal for deterioration and make a water test
• Check for correct operation of bolts and hinges
• Check operation and condition of hatch and combing 

Waists and cockpit

• Check operation of lights and inspect integrity of covers
• Check scuppers clear, deck connections free and seals correct
• Test operation of windlasses
• Test operation of washdown hose
• Test local and remote control operation of passarelle and lights. Check ropes and teak for damage and lubricate runners as reqd
• Open garage door, inspect hinges for security and corrosion. Test lights and winch. Clean rear roller and deck as reqd
• Pull Jet Ski or dingui out into water but leave attached to winch. Carry out engine checks iaw manual and start engine. Test operation of gears and throttle, steering, and kill switch. Clean as reqd
• Check smooth operation of lazarette door and check hinges for security and corrosion
• Test operation of cable spoolers and check seal in caps
• Inspect and clean cushions
• Check the condition and function of the cupboard doors, chest lids and storage places

-    Control water and fuel filler necks. Check their open and close properly and are leak proof

• Check security and condition of flagpole
• Check guard-rails for security and condition
• Check operation and condition of bathing platform ladder

Fly bridge

• Check operation and condition of hatch and combing
• Test operation of barbecue, sink and fridge
• Inspect life raft and check date
• Check operation and condition of deck lights in radar arch
• Check operation and condition of anchor lights and nav lights
• Test searchlight through full range of movement and check cleanliness
• Check security and integrity of radar arch access panels
• Test operation of crane and lubricate wire rope as reqd
• Check security of fittings on radar arch
• Check condition and security of windshield and bimini
• Check scuppers clear
• Top up helm oil as reqd
• Check operation and condition of saloon hatch and combing
• Check operation of speakers from main entertainment system
• Carry out RIB checks iaw manual. Monthly launch rib and test engine, transmission, batteries and buoyancy pods
• Check the number of mattresses awnings and tarpaulins are complete and control their condition

Salon, Galery, Crew- guests,main,-etc. Cabins and bathrooms

Salon 

• Check patio doors and screens for smooth operation and locking
• Test operation of TV, video, audio and sat receiver via all remote sensors
• Check operation of fly bridge hatch and locks
• Test all lights
• Test air con heat/cool for min 15 mins, monthly clean drip tray under chiller
• Test electric window
• Check all tableware, glasses and galley equipment present and correct
• Check operation of all cupboard and drawer runners and catches
• Check all upholstery for cleanliness and condition
• Check of dampness and bad smell

Bathrooms

• Test lights.
• Check operation of all taps and showers, toilet and Drains
• Check General cleanliness
• Check operation of all appliances.
• Check for leaks
• Check operation of cupboard doors.
• Check porthole operation and seal.
• Check toilet roll availability.
• Test fan
• Check door and lock
• Check operation and leaks of toilets and bidet
• Check the bull eyes, hatches and windows.

Cabins

• Test lights
• Check porthole operation and seal
• Test operation of air con heat/cool for min 15 mins
• Check cupboards for smooth hinge action and cleanliness
• Check bulkheads and carpets for condition and cleanliness
• Check all doors operating correctly
• Check mirrors clean and undamaged
• Under floor check bilge for gas/water presence and cleanliness. Check bag in vacuum system
• Check upholstery and carpet for condition
• Check stowage lids for security and freedom of movement
• Test TV and video
• Open hatch check seals and locks
• Test stereo
• Check drawers and cupboards hinges, runners and catches.  

Wardrobe

• Test lights
• Check porthole operation and seal
• Check drawer runners and catches
• Check condition of carpets and upholstery  

Galley

• Test operation of range and extraction.
• Check operation of oven in grill and microwave modes
• Check operation of galley shutters and door
• Run dishwasher through cycle
•  Run trash compactor through cycle
• Check temperature and operation of fridge and freezer On closing, providing for ventilation.
• Operate kettle and toaster
• Check sinks clear and flush with cleaner
• Check cupboards tidy
• Check condition of carpet or teak deck

      Engine room and technical compartments

• Test lights
• Test supply and exhaust fans
• Check bilge level and condition
• Check engine and generator batteries for condition, arcing and tight connections
• Check clarity of gauge glass on fuel tanks, check for leaks
• Check both engine primary filters for water and particulate contamination
• Check both differential oil levels.
• Visually inspect condition or fire fighting cables and halon heads
• Check fuel shutoff solenoids are in auto mode (levers vertical)
• Check stern glands not leaking and sealing water open
• Check engines free from debris, no leaks visible on paint and engines clean
• Check water intake strainers clear
• Check engine oil levels, water levels, belts tight and gearbox oil levels correct
• Check condition of engine intake filters
• Check operating cables from MMC boxes and electrical connections
• Check exhaust lagging and flexi sections of exhaust for burning
• Check generators for oil level, water level, sea strainer clear, belts tight before starting
• Check generator primary fuel filters for water and particulate contamination
• Check lamps on main electrical panel
• Clean washing machine as reqd and run through cycle
• Check Fresh water pressure and both pumps working
• Check accumulator 
• Check operation of fire pump and test hoses once a month.
• Check oil levels in passarelle and check rudder-locking pins secure.
• Check bow thrusters batteries for condition arcing and tight connections
• Check bow thrusters oil level, condition of motor, water seal and ensure switch operates 
• Check for leaks on the shaft and the rudder seals.

Basis trial

• ENSURE BOAT IS TIED FIRMLY ALONGSIDE AND THERE ARE NO FOULING HAZARD
• IN THE VACINITY BEFORE PROCEEDING.

• Ensure there is at least 1 generator running on load
• Ensure all AC and DC breakers are on
• Ensure main engine checks have been carried out
• Check the batteries cross over  or  parllel reles botton parallel  relais botton
• Start engines from main control position allow to idle
• Switch on GPS, check boats position and record ...............................
• Switch on VHF and monitor channel16
• Switch radar to standby
• Check engines idling at 600 rpm +1- 100
• Check gearbox oil pressure
• Check engine oil pressure
• Allow engines to Run at 1000 rpm for 5 mins
• Set engines to 1500 rpm for 30 secs
• Set engines to 2000 rpm for 10 secs
• Set throttles to neutral 600 rpm
• Run trim tabs through full range of movement and set to 0 degrees
• Put radar to XMIT for 1 min, check paint through all ranges, set to standby
• Switch on bow thruster and apply in both directions allowing 10 seconds between bursts
• Set auto pilot to auto, change course using + 1, -1, + 10, -10 and note rudder response
• Set auto pilot to standby and swing helm manually through full range twice and set midships
• Check depth sounder working correctly
• Check helmseat through full range of movement
• Check camera in ER and cockpit working
• Test lamps and note any not working
• Test bilge pumps
• Test horn
• Test nav lights, instrument lights, anchor lights and aux lights
• Test gearboxes and throttles: select ahead on port throttle

                                                     select astern on stb throttle
Note response times equal and both gearboxes engage correctly. Select neutral
                                                     select ahead on stb throttle 
                                                     select astern on port throttle     
Note response times equal and both gearboxes engage correctly. Select neutral

• Stop main engines and proceed to flybridge where gearbox test and autopilot checks must be carried out
• Stop main engines from the flybridge

General

• Check condition and readiness of fire extinguishers, fire hoses and other safety equipment
• Check the shore power lines are OK
• Check the battery charger on all battery banks. Check that he operate with the shore power.
• Ensure all lights off, all gash landed, portholes and windows closed, hatches secured and locked. Proceed to main panel, switch off all breakers from the bottom up, stop all running generators, note engine and generator hours and switch off service batteries.
• Lock doors, retract passerelle, check ropes secured, cushions stowed and fenders present and correct.

Running hours

• Port engine                                            .
• Stbd engine                                    .
• Genset 1                                             .
• Genset 2                                             . 

• The above routine has been carried out by BRAUN YACHTSERVICE in a competent and professional manner and all information on this form is correct to the best of my knowledge.